Connections, Operating And Display Elements; Oled-Display - Cameo ROOT PAR 4 Manuel D'utilisation

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

2
The CLROOTPAR4 and CLROOTPAR6 models feature identical connections, operating and display elements.
POWER IN
1
Blue Power Twist mains input socket. Operating voltage 100–240 V AC/50–60 Hz. A suitable
mains cable with Power Twist plug is included.
POWER OUT
2
White Power Twist mains output socket for supplying power to additional Cameo spotlights (max.
8 A).
DMX IN
3
Male 3-pin XLR socket for connection to a DMX control device (e.g. DMX console).
DMX OUT
4
Female 3-pin XLR socket for sending the DMX control signal.
FUSE
5
Fuse holder for 5 x 20 mm micro fuses. IMPORTANT: Replace the fuse only with a fuse of the
same type and value. In the event of repeated fuse failure, please contact an authorised service
centre.

OLED-DISPLAY

6
The OLED display shows the currently activated mode (main display), the menu items in the
selection menu and the numerical value or operating mode in certain menu items. If there is no
input for around two minutes, the display automatically returns to the main display. Note regard-
ing the main display in operating modes with external control: As soon as the control signal is
interrupted, the characters in the display begin to flash. When there is a control signal again, the
flashing stops. Briefly pressing the UP button when in the main display rotates the display by
180°.
8
1
4
3