Operation - Cameo ZENIT P100 DTW Manuel D'utilisation

OPERATION

NOTES
• The combination of warm white and amber-colored LEDs makes it possible to imitate the color drift of dimming a halogen spotlight. The
dimming of the spotlight automatically changes the color temperature along a rising curve of warm white and amber (and vice-versa). The
amber-colored LED takes effect in the lower DMX range, and does not contribute to the maximum brightness. Activate the function for this
effect in the system settings (Settings: Red Shift = On).
• As soon as the spotlight is correctly connected to the power mains, "Update Wait..." (only for servicing purposes), "Welcome to Cameo",
the model name, and then the software version are displayed in sequence on the display as part of the startup process. Once the process is
complete, the spotlight is ready for use and resumes whichever mode was most recently activated.
• If one of the DMX modes or slave mode is active, and there is no DMX signal at the DMX input, the display and the backlighting of the
control elements will begin to blink after a few seconds.
• After approx. 30 seconds of inactivity, the display will automatically show the currently active operating mode (main display).
• Fast Access feature: In order to make navigating the menu simpler, the device has an intelligent menu structure that makes it possible
to directly access menu and submenu options that were previously selected. 1. Pressing MODE and ENTER at the same time will take you
directly to the submenu option that was last modified, where you can immediately change the value as desired (DMX start address and all
operating modes). 2. Pressing MODE will take you directly to the menu option that was last selected and modified.
• Before changing device settings, make sure that the control unit is dry and dust-free in order to ensure that it is functioning properly.
• The display can be rotated by 180° by pressing UP when the main screen is shown on the display.
SETTING THE DMX START ADDRESS (DMX Address)
You can access the options menu by pressing MODE. Select the "DMX Address" option using UP and DOWN (note arrow) and then press
ENTER. A number field will now be shown, and you can select the desired DMX start address using UP and DOWN (the highest value
depends on the selected DMX mode). Confirm with ENTER. DMX mode and the last selected DMX mode will activate at the same time.
---------- Menu ----------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Information
SETTING DMX MODE (DMX Mode)
You can access the options menu by pressing MODE. Select the "DMX Mode" option using UP and DOWN (note arrow) and then press
ENTER. You can now select the DMX operating mode again as desired using UP and DOWN. Confirm with ENTER. You can find detailed DMX
tables in these instructions under "DMX CONTROL".
---------- Menu ---------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Information
----- DMX Address -----
DMX Address
001
DMX Mode
Stand Alone
------- DMX Mode ------
1 CH
2 CH1
2 CH2
2 CH3
4 CH
DMX Address
001
7