Operation - Cameo INSTANT AIR 2000 PRO Manuel D'utilisation

SPEED
7
Speed controller to set the fan speed in manual mode and when operating via RF remote control.

OPERATION

The device is ready to be used after being connected to the power supply. The control keys have back lighting, which switches on
automatically when the keys are pressed and switches off automatically approx. 15 seconds after pressing said keys. If there is a pending
DMX signal on the device, DMX mode will be forcibly activated. CAUTION: Never reach through the protective grille, there is a risk of injury!
Never stick items through the protective grille! Special caution should be exercised by people with long hair; long hair can be drawn in and
entangled in the fan, causing serious injury!
CONFIGURING DMX MODE
End manual mode as needed by pressing the START/STOP (MODE) button. If there is no DMX signal, the display will now show 3 minus
signs; if there is a signal, the DMX address will display. Use the UP and DOWN keys to set the desired DMX address (001 - 512, hold the
button for rapid value adjustment). The simultaneous control of multiple devices of the same model with a DMX control unit (e.g. DMX mixer)
can be achieved by setting identical DMX start addresses on the devices and connecting them via DMX cables. You can find DMX tables on
channel assignment in these instructions under DMX CONTROL.
MANUAL MODE
If there is a pending DMX signal on the device, manual operation will not be possible; the device must be disconnected from a DMX net-
work. Now use the START/STOP button to activate manual mode (press briefly). Change the fan speed using knob no. 7 to 99 (turning left =
minimum speed, turning right = maximum speed). To end manual mode, briefly press the START/STOP button again.
CONTROL VIA RF REMOTE CONTROL.
Separate the wind machine from a DMX network. Press and hold the START/STOP (MODE) button for a duration of approx. 5 seconds in or-
der to activate RF remote control (point between 1st and 2nd position on the display illuminates). The provided RF remote control (433 MHz)
has a sliding cover in order to protect the control keys from accidental activation. To this end, push the protective cover up over the control
keys. Push the protective cover down to the catch in order to free the control keys and control the wind machine using the RF
remote control. The LED on the control panel will illuminate as soon as one of the control keys is pressed. If the LED does not illuminate
when pressing a key, the internal batteries must be replaced. To do so, remove the three screws on the rear side of the remote control
(battery type: 27A, 12V). Deactivate RF remote control by pressing and holding the START/STOP (MODE) button for a duration of approx. 5
seconds (point between 1st and 2nd position on the display illuminates).
Control keys
A - start fan
B - stop fan
C - increase speed
D - decrease speed
6