Operation - Cameo ZENIT Z120 G2 Manuel D'utilisation

TOUCH-SENSITIVE CONTROLS
6
MODE
Press mode to access the selection menu for system settings. Press repeatedly to go back to the main display.
ENTER
Press ENTER to access the menu levels to make value changes, and to access the sub-menus. Confirm value changes by pressing ENTER.
UP and DOWN
Select individual menu items in the selection menu (DMX address, operating mode etc.) and in the sub-menus. Allow changes to the value
of a menu item, such as the DMX address as required.
PRESSURE EQUALISATION ELEMENT
7
Pressure equalisation element to prevent condensation inside the housing. In order to ensure its proper function, the element must be
protected from contamination.
SECURING LUG
8
For overhead installation, secure the device to the securing lug with a suitable safety rope.
PLEASE NOTE: In order to provide protection from spraying water, in accordance with protection class IP65, special IP65-rated XLR connec-
tors must be used correctly with the DMX input and output sockets, or they must be closed using the rubber sealing caps. When connected
correctly, or when sealed correctly with the rubber sealing caps, the POWER IN and POWER OUT sockets are protected from spraying water,
as in accordance with IP65.

OPERATION

PLEASE NOTE
• As soon as the spotlight is correctly is connected to the power supply, the following will be displayed in succession: "Update Wait..." (only
for service purposes), "Welcome to Cameo", the model name and the software version. The zoom unit also initialises during start-up. After
this process, the lamp is ready for operation and starts in the previously selected mode.
• If one of the DMX operating modes is activated and there is no DMX signal at the DMX input, the display will start to flash after a few seconds.
• After approximately 30 seconds of inactivity, the display will automatically show the currently active operating mode (main display).
• Fast Access Feature: In order to simplify the menu guide, the device has an intelligent menu structure that allows direct access to
previously selected menu items and sub-menu items. 1. Press MODE and ENTER simultaneously for direct access to the last-edited
sub-menu item, where you can make changes instantly as required (DMX starting address and all modes). 2. Press MODE to go directly to
the last selected and edited menu item.
• Before changing device settings, ensure that the control panel is dry and dust free, in order not to impair its functionality.
• The display can be rotated through 180° by pressing UP when the main display is visible.
SETTING DMX START ADDRESS (DMX Address)
Press MODE to access the selection menu. Now select the menu item "DMX Address" using the UP and DOWN keys (observe arrow) and
press ENTER. Now select the desired DMX starting address using the UP and DOWN keys and confirm with ENTER (the highest value is
dependent on the selected DMX mode). The DMX mode will start and the last-selected DMX mode will be activated simultaneously.
---------------- Menu ----------------
 DMX Address
DMX mode
Stand Alone
Slave
Settings
System Information
6
001
–
DMX Address
5xx
001