W-Dmx™ Status - Cameo ZENIT B60 Manuel D'utilisation

BATTERY CHARGE STATUS IN STANDBY MODE
To recharge the internal battery, connect the lamp to the mains with the supplied power cable. The battery charge status is indicated by the
battery symbol on the display.
W-DMX™
To pair with W-DMX™ compatible transmitters, enable W-DMX™ in the device settings (Settings -> Wireless Setting -> Receive -> On) and reset
the W-DMX™ module (Receive Reset -> Yes). Start the pairing process as described in the operating instructions of the W-DMX™ transmitter.
Pairing is then completed automatically.
W-DMX™ STATUS
W-DMX™ deactivated
SETTING DMX START ADDRESS (DMX ADDRESS)
Press MODE to access the device settings selection menu (--- Menu ---). Using the UP and DOWN controls, select the menu item "DMX
address" (observe arrow) and confirm with ENTER. The display will show a three-digit number field and you can use the UP and DOWN
controls to configure the desired DMX start address. Confirm the entry with ENTER and press MODE to return to the main display (in the
example, "DMX address 001").
---------------- Menu ----------------
DMX Address
Mode
Settings
SETTING OPERATING MODE (Mode)
Press MODE to access the device settings selection menu (--- Menu ---). Using the UP and DOWN controls, select the menu item "Mode"
(observe arrow) and confirm with ENTER. Using the UP and DOWN controls, you can now select one of the following operating modes:
"DMX", "Slave", "Auto", "Static", " Color Macro" and " User Color". Confirm your entry with ENTER.
---------------- Menu ----------------
DMX Address
Mode
Settings
8
W-DMX™ activated, W-DMX™ activated
not paired
transmitter switched
001
DMX Address
001
---------------- Mode ----------------
DMX
Slave
Auto
Static
Color Macro
User Color
W-DMX™ activated
and
device paired, device paired,
no DMX signal
off,
or out of range
W-DMX™ activated
and and
device paired,
DMX signal is present