Ir Remote Control - Cameo ZENIT B60 Manuel D'utilisation

SYSTEM INFORMATION (System Info)
Press MODE to access the device settings selection menu (--- Menu ---). Using the arrow keys, select the menu item "System Info"
(observe arrow) and confirm with ENTER.
------------------- Menu -------------------
Mode
Settings
System Info
Use the UP and DOWN controls to select the desired sub-menu item, and press ENTER to display the corresponding information.
System Info
Firmware =
Temperature =
Operation Hours =
MANUAL LOCKING FUNCTION
In addition to the ability to protect the lamp automatically from accidental and unauthorised operation (see "Settings" - "Auto-lock"), the
controls can also be locked manually. Press and hold the UP and DOWN controls simultaneously for approximately 5 seconds. If an attempt
is made to change settings, "Locked!" will appear in the display and changing the lamp's settings via the controls is no longer possible.
After approx. 1 minute, the current operating mode is displayed again. To unlock, press and hold the UP and DOWN controls simultaneously
for approximately 5 seconds.
The display will show the previously displayed information.

IR REMOTE CONTROL

BLAC K
SOUN D
AU TO
OUT
SENS I
STROBE SPEED
TIVITY
%
MANUAL FADE
R G B
A W
UV
+
-
0
1 2 3
4 5 6
7 8 9
12
Displays device firmware
Displays temperature of LED unit
Displays operating time
Aim the infrared remote control directly at the infrared sensor on the front of the lamp. The maximum
range is approximately 8 metres. In DMX and Slave modes, the remote control is deactivated. Battery
for IR remote control = CR2025.
-
Blackout
Auto-programme
Strobe
Speed
Brightness
Manual colour mix
Main CPU Vx.x
LED Temp xx°C / xx°F
Unit °C (= display in degrees Celsius)
°F (= display in degrees Fahrenheit)
xx:xx h Displays total operating time in hours and minutes
The blackout button is used to switch off all LEDs, regard-
less of operating mode enabled via the remote control.
Press the blackout button again to reactivate the previously
selected mode.
Auto-Programmes 1 - 6. Programme selection with
and . Programme run speed with
and . Brightness setting with
No function.
Strobe light for AUTO, FADE and MANUAL operating modes.
Press to activate. Strobe speed with
Press to deactivate strobe.
Setting the running speed for Auto and Fade programmes.
No function.
Press and
Press and
colours. Adjust intensity with
and
and and
and
and to adjust brightness.
, , or to manually mix
and .
.
.