Cameo ZENIT B60 Manuel D'utilisation page 10

COLOUR MACROS (Color Macro)
15 different preset colour macros are available. Select colour macro mode as per the procedure previously described in SETTING OPERATION
MODE and confirm with ENTER. Using the UP and DOWN controls, now select the desired colour preset (observe arrow) and confirm with ENTER
(Color Off = blackout). A three-digit figure is shown on the display and you can set the desired brightness on a scale from 000 to 1000 using UP
and DOWN. Confirm by pressing ENTER. Press MODE three times to return to the main display (Colour Macro Mode).
---------------- Mode ----------------
Auto
Static
Color Macro
USER PRESETS (User Color)
The operating mode "User Presets" allows the overall brightness and a colour mixture of R, G, B and W to be saved directly in the device in five
individual colour presets. Select the menu item "User Color" as described above in SETTING OPERATION MODE and confirm with ENTER. Now
use UP and DOWN to select presets Color1 to Color5, confirm with ENTER and select the submenu item you would like to edit (observe arrow).
Confirm by pressing ENTER. The display will show a three-digit number field and you can use the UP and DOWN controls to configure the value
between 000 and 255 as required. Confirm again with ENTER. Once all settings have been made according to preference, press MODE four
times to return to the main display (Mode User Color).
---------------- Mode ----------------
DMX
Slave
Auto
Static
Color Macro
User Color
DEVICE SETTINGS (Settings)
Press MODE to access the device settings selection menu (--- Menu ---). Using the UP and DOWN controls, select the menu item "Settings"
(observe arrow) and confirm with ENTER.
---------------- Menu ----------------
DMX Address
Mode
Settings
This will take you to the sub-menu for configuring the following sub-menu items:
Settings
Runtime =
Display Reverse =
Display Backlight =
DMX Fail =
10
------------ Color Macro ------------
Color Off
Red <100>
Amber <100>
Yellow Warm <100>
Yellow <100>
Green <100>
Turqoise <100>
Cyan <100>
------------ User Color ------------
Color1
Color2
Color3
Color4
Color5
Increase battery life by up to 24 hours with
correspondingly reduced brightness
(calculated on full with 100% battery)
Flip display
Display lighting
Operating status with DMX signal fault
Blue <100>
Lavender <100>
Mauve <100>
Magenta <100>
Pink <100>
Warm White <100>
White <100>
Cold White <100>
------------ Color1 ------------
Dimmer <255>
Red <255>
Green <255>
Blue <255>
White <255>
Off Function deactivated
4 hours - Configure battery run time from 4
24 hours hours to 24 hours in 1 hour incre-
ments.
On Rotate display by 180° (e.g. for over-
head installation)
Off No display rotation
On on permanently
Off Deactivation after approximately 1
minute of inactivity
Hold Last command is retained
Blackout Activates blackout
Emergency Light Lamp changes to colour macro "Cold
White"
Mode
Color Macro
001
Mode
-
User Color
100