Diffusers; Optional Accessories; Installation And Assembly - Cameo ZENIT B60 Manuel D'utilisation

Table des Matières

Les langues disponibles

DIFFUSERS

Two diffusers are supplied with the lamp, each with a different beam angle (1 x 25° with notched edge for identification, and 1 x 40°). The beam

angle of the lamp can be adjusted to 11° (without diffuser), 25°, or 40°. Place the desired diffuser (rough side facing front glass) in the provided

rubber frame, release the spring-loaded retaining pin (pull handle outwards approx. 1 cm), position the diffuser as shown in front of the front

glass of the lamp and release the retaining pin in order to insert it into the slot in the rubber frame.

Elliptical disc with 60° x10° available - CLZPLSD6010

Thanks to its integrated double bracket, the lamp can be positioned in a suitable location on a level surface. Installation on a traverse is

possible with a suitable traverse clamp (not supplied). Ensure firm connection to the mounting bracket and secure the lamp at the specified

position (A) with a suitable safety cable. Important: Overhead installation must only be carried out by qualified personnel.

Fade programmes

Colour preset

Fade programmes Auto 1 - Auto 5. Programme selection

with

and

. Programme run speed with

and

. Brightness setting with

and

Direct selection of colour presets 0 to 9.

and

Table des Matières

Clzb60blsd Clzb60clsd