Diffusers; Installation And Mounting - Cameo Q SPOT 40 RGBW Manuel D'utilisation

R / G / B / W / A / U (red, green, blue, white / A and U without function)
Individual colour mixtures can be created with the 4 buttons R, G, B, and W. To set one of the 12 brightness levels, press the respective colour
key, then use the + and - buttons to select the level, whereby level 1 switches the LEDs off.
Example: Set red and green at maximum brightness, and blue and white at minimum (i.e. off), and you will achieve a bright yellow colour mix.
PG (Auto Jump / Auto Fade)
Press the PG button and select the mode "Auto Jump" or "Auto Fade" using the + and - buttons. Set the programme run-speed by pressing SP
and using the + and - buttons.
CM (Colour Macros)
15 colour presets can be retrieved by pressing CM and using the + and - buttons.
SC (sound-controlled colour-change programme)
To activate the sound control mode, press SC and set the microphone sensitivity between 1 and 11 using the + and - buttons as required
(11 levels).
AU (Auto Programme)
= automatic switching between "Auto Jump" and "Auto Fade". The speed is set with the buttons SP and + and -.

DIFFUSERS

Two diffusers are supplied with the lamp, each with a different beam angle (1 x 10° and 1 x 25°). The beam angle of the lamp can be set at
4.5° (without diffuser), 10°, or 25°. Insert the desired diffuser in front of the light-emitting lens and secure it with the supplied securing ring.

INSTALLATION AND MOUNTING

Thanks to its integrated double bracket, the lamp can be positioned in a suitable location on a level surface. Installation on a traverse is possible
with a suitable traverse clamp (not supplied). Ensure firm connection to the mounting bracket and secure the lamp at the specified position (A)
with a suitable safety cable.
Important: Overhead installation must only be carried out by qualified personnel.
A
11