Infrared Remote Control - Cameo Q SPOT 40 RGBW Manuel D'utilisation

ENTER
UP/DOWN

INFRARED REMOTE CONTROL

Activate the infrared remote control in system settings under "IR remote" (IR Remote On). Aim the infrared remote control
directly at the infrared sensor built into the front of the spotlight. The maximum range is approximately 8 metres.
BL / ON/OFF (Blackout)
The BL button is used to switch off the spotlight, regardless of operating mode. Press the BL button again to reactivate the previously
selected mode.
SP / SPEED
11-speed setting for the operating modes "Auto Jump", "Auto Fade" and "Auto Program". First press the key SP and then select the desired
speed using the + and - buttons. Level 1 provides a slow colour-change sequence. Press again to activate level 2 for a faster colour-change
sequence, and repeat for levels 3 to 11, whereby level 11 provides the maximum colour-change sequence speed.
/ BRIGHTNESS
12 brightness settings. Press the button
FL / FLASH (Strobe)
Activate the strobe effect and set one of its 14 speeds. Press the FL button, then use the + and - buttons to select the flash frequency (level
1 = strobe disabled, level 2 = slowest flash frequency, level 14 = fastest flash frequency).
10
ENTER
ENTER
/
ENTER
UP/DOWN
ENTER
/
ENTER
and then select the desired brightness using the + and - buttons (level 1 = Blackout).
/ /
ENTER-UP/ DOWN
/
ENTER ENTER