Music Control; Slave Mode; Operation Using The Ir Remote Control - Cameo TRIBAR 400 IR Manuel D'utilisation

AUTO MODE
Press the MODE button repeatedly until "AUTO" appears on the display. The Auto mode combines the internal colour change programs, that is,
the programs PG01 to PG12 are automatically activated in sequence. The running speed arises from the settings in programs PG01 to PG12.

MUSIC CONTROL

Press the MODE button repeatedly until "SOxx" appears on the display. Now the spotlight is controlled by the built-in microphone and the
colour changes follow the beat of the music (bass pulses). Use the UP and DOWN buttons to select the sensitivity of the microphone (setting
"SO00" = lowest, "SO31" = highest microphone sensitivity).

SLAVE MODE

Press the MODE button repeatedly until "SLA-" appears on the display. Connect the slave and the master unit (same model) with a DMX
cable and activate one of the standalone modes (Auto, Music control...) on the master unit. Now the slave unit follows the master unit.

OPERATION USING THE IR REMOTE CONTROL

Point the infrared remote control directly at the infrared sensor installed on the front of the spotlight. The maximum range is about 8 metres.
In the DMX and slave modes, the sensor on the spotlight is disabled.
BL (BLACKOUT) / ON/OFF
The BL button is used to activate blackout (switch off the lights), regardless of which operating mode is enabled on the remote control.
Pressing the BL button once more activates the previously selected mode again.
SP (SPEED / SPEED)
11-level speed setting for the programs PG01 to PG12. First, press the SP button and then select the desired speed using the + and - but-
tons. Level 1 makes the colour change sequence run slowly. Pressing again activates level 2 with a faster colour change sequence, followed
by levels 3 to 11, whereby level 11 activates the fastest colour change sequence.
(BRIGHTNESS / BRIGHTNESS)
11-level brightness adjustment for the programs PG01 to PG12, the colour macros CM, the sound control mode SC and the Auto mode AU.
First, press the BRIGHTNESS button and then select the desired brightness using the + and - buttons.
FL (FLASH/ STROBOSCOPE)
Stroboscope effect for the programs PG01 to PG12, the colour macros CM, the mode for colour mixing RGBWAU and depending on the
model, the Auto mode AU. After pressing the FL button, select the flash frequency (10 levels) using the + and - buttons. Level 1 activates the
slowest (about 1 Hz) and level 10 the fastest flash frequency (20 Hz).
R / G / B (RED, GREEN, BLUE, - W, A ,U WITHOUT FUNCTION)
These 3 buttons can be used to create individual colour combinations. The 10 levels of brightness can be selected by pressing the corresponding
colour button, then using the + and - buttons, whereby, at level 1, the LEDs are switched off.
For example: If you set red and green to their respective highest level and blue and white to their lowest, i.e., off, the result will be a bright
yellow colour mix.
PG (PROGRAMS PG01 - PG12)
First, press the PG button and then select the desired program PG01 to PG12 using the + and - buttons. Select the speed at which the
programs are running, using the SP (Speed) and + and - buttons.
CM (COLOUR MACROS)
Colour presets that can be accessed using the CM and + and - buttons. The colour sequence is red, green, blue, cyan, yellow, magenta,
white, blackout..
SC (MUSIC-CONTROLLED COLOUR CHANGE PROGRAM)
To select the Music control mode on the spotlight, press the SC button. The sensitivity of the internal microphone is adjusted using the +
and - buttons.
7