Connections, Controls And Indicators; Power Input; Led Display - Cameo TRIBAR 400 IR Manuel D'utilisation

CONNECTIONS, CONTROLS AND INDICATORS

POWER IN: AC 100-240V 50Hz-60Hz
POWER CONSUMPTION: 50W
1
FUSE: F 1A L / 250V
1

POWER INPUT

IEC power socket with built-in fuse holder. Connection via the included IEC power cord.
IMPORTANT INFORMATION: Replace the fuse only with a fuse of the same type and rating. If the fuse blows repeatedly, please contact an
authorised service centre.
2
DMX IN
3-pin male XLR socket for connection of a DMX controller (e.g. DMX console).
3
EYELETS FOR SAFETY ROPE
Overhead installation should only be carried out by trained personnel. The spotlight must be secured with appropriate safety ropes to
prevent falling.
4

LED DISPLAY

The four-digit LED display indicates the operating mode and other system information.
5
CONTROL BUTTONS
MODE: Selecting the different operating modes and system settings.
ENTER: Selecting the sub-menu items program running speed and stroboscope frequency.
UP and DOWN: Adjusting the colour macros, program running speed, stroboscope frequency and the DMX address.
3
many
safety rope
Y. ASSEMBLED IN PRC
6
DMX OUT
3-pin XLR socket for looping through the DMX control signal.
7
POWER OUT
The IEC mains output socket is used to supply power to additional CAMEO spotlights. Make sure that the total current consumption in
amperes (A) of all connected devices does not exceed the specified value on the device.
2
DMX IN
6
DMX OUT
3
safety rope
7
POWER OUT MAX: 3A
5