Connections, Controls And Indicators - Cameo MOVOBEAM 100 Manuel D'utilisation

CONNECTIONS, CONTROLS AND INDICATORS

3
1
POWER IN
Blue power input socket. Operating voltage 100 - 240 V AC / 50 - 60 Hz. Connection via the included power cable.
2
POWER OUT
White power output socket. Used to supply power to additional CAMEO spotlights. Make sure that the total current consumption in amperes
(A) of all connected devices does not exceed the specified value on the device.
3
DMX IN
3-pin male XLR socket for connection of a DMX controller (e.g. DMX console).
4
DMX OUT
3-pin female XLR socket for looping through the DMX control signal.
5
BACKLIT GRAPHIC DISPLAY
Displays the operating mode and other system settings.
6
CONTROL BUTTONS
MODE
Pressing MODE will take you to the selection menu for system settings. Repeatedly pressing MODE takes you back to the main display.
UP and DOWN
Selecting the individual menu items in the selection menu for the system settings (DMX address, operating mode, etc.) and sub-menus.
These panels allow you to change the value of a menu item as required, such as the DMX address.
ENTER
Pressing ENTER will take you to the selection menu for the sub-menus to adjust values. Confirm the value changes by pressing ENTER again.
1 2
5
4
6
5