Connections, Controls And Indicators; Led Display - Cameo LED FLASH MATRIX 250 Manuel D'utilisation

CONNECTIONS, CONTROLS AND INDICATORS

5
6
1
POWER IN
IEC power socket with built-in fuse holder. An appropriate power cord is included in the delivery. IMPORTANT INFORMATION: Always replace
the fuse only with a fuse of the same type with the same rating (printed on the device). If the fuse blows repeatedly, please contact an
authorised service centre.
2
POWER
On / Off switch for the power supply of the device.
3
POWER OUT
IEC mains output socket. Used to supply power to additional CAMEO spotlights. Make sure that the total current consumption in amperes (A)
of all connected devices does not exceed the specified value on the device.
4
DMX INPUT
3-pin male XLR socket for connection of a DMX controller (e.g. DMX console).
5
DMX OUTPUT
3-pin female XLR socket for looping through the DMX control signal.
6
SAFETY EYELET
Overhead installation should only be carried out by trained personnel. The spotlight must be secured with appropriate safety ropes to
prevent falling.
7

LED DISPLAY

The four-digit LED display indicates the operating mode and other system information.
8
CONTROL BUTTONS
MODE: Selecting the different options for operating modes and system settings.
ENTER: Confirm value changes and program selection.
UP and DOWN: perform value changes, such as program speed and DMX address, and select programs.
9
MIC
Microphone for music control mode.
4
3
7
8
1
2
9
5