Slave Mode; Setting Up And Mounting - Cameo LED FLASH MATRIX 250 Manuel D'utilisation

STROBOSCOPE
Press the MODE button repeatedly until the brightness value between v000 and v255 appears on the display (value xxx). Using the UP and
DOWN buttons, adjust the brightness as required (v000 = blackout, v001 = minimum brightness, v255 = maximum brightness) and confirm
the entry with ENTER. Press the MODE button once to access the menu item for adjusting the strobe speed. The currently set value will
be shown on the display and you can use the UP and DOWN buttons to make adjustments as required (F000 = minimum speed, F010 =
maximum speed). To confirm your selection and activate the strobe, press ENTER again.
UP/DOWN
-

SLAVE MODE

Press the MODE button repeatedly until "SLoF" or "SLon" appears on the display. Now use the UP and DOWN buttons to select "SLoF" for
"Slave operation disabled" or "SLon" for "Slave mode enabled" and press ENTER to confirm. When the slave mode is enabled, connect the
slave and the master unit (same model) using a DMX cable and activate one of the standalone modes on the master unit. Now the slave unit
follows the master unit.
UP/DOWN
ROTATE THE DISPLAY BY 180
Press the MODE button repeatedly until "rdoF" or "rdon" appears on the display. Now use the UP and DOWN buttons to select "rdoF" for
"Display rotation disabled" or "rdon" for "Display rotation enabled" and press ENTER to confirm.
UP/DOWN

SETTING UP AND MOUNTING

Thanks to the integrated double bracket, the spotlight can be placed in a suitable location on a flat surface. Mounting on a truss is per-
formed with the help of a suitable truss clamp (not included). Make sure that the connection to the mounting bracket is solid, and secure
the device with a suitable safety rope to the safety eyelet provided (A). Important Notice: Overhead installation should only be carried out by
trained personnel.
-> ENTER -> MODE
/ -> ENTER
/ -> ENTER
UP/DOWN
-
A
-> ENTER
7