Slave Mode - Cameo COB LED STROBES Manuel D'utilisation

OPERATION:

SLAVE MODE

Set the light that is to serve as a slave unit to the DMX start address mode.
Connect the slave and master unit of the same type with a DMX cable
(master unit DMX OUT -- slave unit DMX IN). Set the brightness and flash
frequency on the master unit. Now the slave unit follows the master unit.
Connection to an analogue controller
Up to five stroboscopes can be connected to one another and to an analogue
strobe controller (10V impulse signal) via the two TRS sockets on the rear of
the device. To make a connection, please use instrument cable with mono
TRS plugs.
NOTE
Unless one of the 3 buttons is pressed, the LED display switches off
automatically after approx. 8 seconds. As soon as one of the three buttons is
pressed, the display switches on again.
9