Cameo COB LED STROBES Manuel D'utilisation page 8

OPERATION:
Connections, control, and functions of the CAMEO stroboscopes
CLSTROBE1 and CLSTROBE2 are identical.
SETTING THE FLASH FREQUENCY
Press the MODE button repeatedly until "F-_" appears in the display. Now use the
UP and DOWN buttons to select the desired flash frequency from F-0 (slowest) to
F-9 (fastest).
SETTING THE BRIGHTNESS
Press the MODE button repeatedly until "C-_" appears in the display. Now use the
UP and DOWN buttons to select the desired brightness of the stroboscope from C-0
(blackout, LEDs deactivated) to C-9 (brightest setting).
MUSIC CONTROL
Press the MODE button repeatedly until "S-_" appears in the display. Now the
stroboscope is controlled by the built-in microphone and follows the beat of the
music. Now use the UP and DOWN buttons to select the desired sensitivity with
which the built-in microphone reacts to sounds, from S-0 (microphone deactivated)
to S-9 (maximum microphone sensitivity).
SETTING THE DMX START ADDRESS
Press the MODE button repeatedly until "Add" appears in the display. Now use the
UP and DOWN buttons to select the desired DMX start address (001 - 512).
Note: In order to be able to use the light in DMX mode, the DMX start address mode
must be set.
8