Dimmer Curves; System Info - Cameo MOVOBEAM 100 Manuel D'utilisation

Pan Rev =
Tilt Rev =
Feedback =
Fan Control =
Mov Blackout =
Calibrate =
TEST =
Reset =

DIMMER CURVES

linear
DMX value
DEVICE INFORMATION (System Info)
Pressing MODE will take you to the selection menu for system settings. Using UP and DOWN, select the menu item "System Info" (coloured
background) and confirm with ENTER. You will then be taken to the sub-menu to display the device information. Use the UP and DOWN panels
again to select the desired sub-menu item and then press ENTER to retrieve the information.
DMX 35 Ch DMX 35 Ch
ADDRESS 001 Software Ver
MODE xxx Temp info
Setting Time info

System Info

System Info
Software Ver =
Temp info =
Time info =
Press the MODE button repeatedly to return to the main display. The main display is automatically activated if no input is made within about
30 seconds.
10
Pan Reverse
Tilt Reverse
position correction
Fan Speed
Automatic blackout during head movement
Correction of the head position of Pan and Tilt
Function test
Reset
exponential logarithmic
DMX value DMX value
VR.xx
Displays the device software version
Temperature display of the LED unit
Operating time display
Normal = no reversal of the Pan direction
Reverse = Reversal of the Pan direction
Normal = no reversal of the Tilt direction
Reverse = Reversal of the Tilt direction
ON = activates automatic position correction
OFF = deactivates automatic position correction
Regular = maximum brightness at normal fan function
Silent = if necessary, reduced brightness with
silent fan
ON = Blackout during head movement
OFF = no blackout during head movement
Pan Position correction value -128 to +127
Tilt Position correction value -128 to +127
OFF = stops the function test
ON = step-by-step function test of LEDs and
motors (approx. 30 seconds)
Pan&Tilt = Resetting of the Pan & Tilt motors
All = Resetting all motors and settings
S-curve
DMX value
VR. xx
LED Temp xxC / xxF
Temp Unit Celsius (= display in degrees Celsius)
Fahrenheit (= display in degrees Fahrenheit)
Power on Displays the total operating time in hours
Last Run Hrs Displays the operating time since the last operation