Operation - Cameo MOVOBEAM 100 Manuel D'utilisation

OPERATION

NOTE:
When the spotlight is properly connected to the mains, "Welcome to Cameo", the model name and software version appear successively on
the display during the start-up process and the motor reset. After this step, the spot is ready for operation and the operating mode that was
previously selected is activated.
MAIN DISPLAY DMX MODE
In the upper line of the display, the DMX mode (DMX 4 Ch, 15 Ch, 20 Ch, 35 Ch) is displayed and the DMX start address is prominently
shown in the centre (for example DMX 35 Ch and ADDRESS 001). As soon as the DMX signal is interrupted, the display starts flashing; if the
DMX signal is present again, the display stops flashing.
DMX 35Ch
ADDRESS
001
MAIN DISPLAY SLAVE MODE
In the upper line of the display, the preset DMX mode is displayed and "SLAVE" is prominently shown in the centre. As soon as the control
signal is interrupted, the display starts flashing; if the control signal is present again, the display stops flashing.
DMX 35Ch
Operating Mode
SLAVE
MAIN DISPLAY STANDALONE MODE
In the upper line of the display, the preset DMX mode is displayed and the currently activated Auto mode (AUTO1 - AUTO8), or the static
mode STATIC, is shown in the centre.
DMX 35Ch DMX 35Ch
Operating Mode Operating Mode
AUTO1 STATIC
SETTING THE DMX START ADDRESS (ADDRESS)
Pressing MODE will take you to the selection menu for system settings. Using UP and DOWN, select the menu item "ADDRESS" (coloured
background) and confirm with ENTER. This is followed by the display of the menu item "Set DMX Address". Press ENTER again to select
the DMX start address as desired by using the UP and DOWN buttons. If the start address is changed, the address colour changes to red.
Confirm with ENTER and press MODE twice to return to the main display. The main display is automatically activated if no input is made
within about 30 seconds.
DMX 35 Ch DMX 35 Ch
ADDRESS 001 Set DMX Address
MODE DMX 35CH
Settings
System Info
SETTING THE DMX MODE (DMX Mode)
Pressing MODE will take you to the selection menu for system settings. Using UP and DOWN, select the menu item "MODE" (coloured
background) and confirm with ENTER. Now use the UP and DOWN buttons once more to select the "DMX Mode" sub-menu item and confirm
by pressing ENTER. Using UP and DOWN, select the desired DMX mode (DMX 4 Ch, DMX 15 Ch, DMX 20 Ch, DMX 35 Ch) and confirm with
ENTER. Press MODE twice to return to the main display. The main display is automatically activated if no input is made within about 30
seconds. You will find tables with the channels of the different DMX modes in this manual under DMX CONTROL.
DMX 35 Ch DMX 35 Ch
ADDRESS 001 DMX Mode
MODE DMX 35CH Slave
Setting Auto
System Info Static
6
DMX 35 Ch
001
Set DMX Address
001
DMX 35 Ch
Yes DMX 4 Ch
DMX 15 Ch
DMC 20 Ch
DMX 35 Ch Yes