Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
System Info
Firmware
=
Temperature
=
Operation Hours
=
MANUAL LOCKING FUNCTION
In addition to the ability to protect the lamp automatically from accidental and unauthorised operation (see "Settings" - "Auto-lock"), the con-
trols can also be locked manually. Press and hold the UP and DOWN controls simultaneously for approximately 5 seconds. If an attempt is made
to change settings, "Locked!" will appear in the display and changing the lamp's settings via the controls is no longer possible. After approx. 1
minute, the current operating mode is displayed again. To unlock, press and hold the UP and DOWN controls simultaneously for approximately
5 seconds.
The display will show the previously displayed information.
IR REMOTE CONTROL
12
Displays device firmware
Displays temperature of LED unit
Displays operating time
Aim the infrared remote control directly at the infrared sensor on the front of the lamp. The maximum
range is approximately 8 metres. In DMX and Slave modes, the remote control is deactivated. Battery
for IR remote control = CR2025.
Blackout
Auto programme
Color macro
Strobe
Speed
Individual color macros
Brightness
Manual color mix
Fade programmes
-
Color preset
Main CPU
Vx.xx
LED driver
Vx.xx
LED
xx°C / xx°F
Unit
°C (= display in degrees Celsius)
°F (= display in degrees Fahrenheit)
xx:xx h
Displays total operating time in hours and minutes
The blackout button is used to switch off all LEDs, regard-
less of operating mode enabled via the remote control.
Press the blackout button again to reactivate the previously
selected mode.
Auto-Programmes 1 - 6. Programme selection with
and
. Programme run speed with
and
. Brightness setting with
Color Macros 1-15. Selection with
Strobe light for AUTO, FADE and MANUAL operating modes.
Press
to activate. Strobe speed with
Press
to deactivate strobe.
Setting the running speed for Auto and Fade programmes.
Individual color macros 1-5. Selection with
Press
and
and
Press
and
,
colors. Adjust intensity with
Fade programmes Auto 1 - Auto 5. Programme selection
with
and
. Programme run speed with
and
. Brightness setting with
and
.
Direct selection of color presets 0 to 9.
and
and
and
.
and
.
and
.
and
.
to adjust brightness.
,
or
to manually mix
and
.
and
and
Publicité
Table des Matières
