Cameo ZENIT W300 Manuel D'utilisation page 11

Dimmer Response = Dimmer sensitivity
Color Calibration = Color calibration
(If one of the DMX factory
calibration modes is activated,
no other calibration can be
selected and the message
"no possible change in this
DMX Mode" will be shown
on the display. If one of the
DMX user calibration modes
is activated, RAW can be
selected as the alternative
calibration.)
Autolock = Automatic locking of the
controls
LED Frequency = LED PWM frequency
IR Remote = Activate or deactivate control
by IR remote control
Fan = Adjusts fan speed
Factory Reset = Reset to factory settings
Dimmer curves
linear
DMX value
SYSTEM INFORMATION (System Info)
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu item "System Info" (observe arrow) and
confirm with ENTER.
------------------- Menu ---------
----------
DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
Use the UP and DOWN controls to select the desired submenu item, and press ENTER to display the corresponding information.
LED
Halogen
RAW
User calibration
Factory calibration
On
Off
800Hz / 1200Hz /
2000Hz / 3600Hz /
12kHz / 25kHz
On
Off
Auto
Max Intensity
Low Noise
Reset Now!
exponential logarithmic
DMX value DMX value
Lamp responds abruptly to changes in DMX value
Lamp behaves like a halogen spotlight with soft bright-
ness changes
individual color calibration. Brightness adjustment of 4
RGBW LED groups for all modes in the range 000-255
Individual color calibration. Cross-mode brightness
setting of the 4 LED groups RGBW with values from
000 - 255
Factory-default calibration of R, G, B, and W (across all
operating modes). Select this setting to ensure the con-
sistent-looking presentation of color macros in stand-
alone mode and to control color macros with DMX.
Automatic locking of the controls after approximately 1
minute of inactivity. Display shown upon attempted use:
"Locked!"
To unlock: Press and hold UP and DOWN simultaneously
for approx. 5 seconds
Automatic locking of the controls is disabled
Configuration of LED PWM frequency
IR remote control activated
IR remote control deactivated
Automatic fan speed control
Maximum fan power for maximum brightness
deactivated fans with reduced brightness
Reset to factory settings:
Confirm with ENTER. Cancel with MODE
S-curve
DMX value
11