Cameo ZENIT W300 Manuel D'utilisation page 10

SLAVE MODE CONFIGURATION
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu item "Slave" (observe arrow) and confirm with
ENTER. Connect the slave and the master units (same model) with a DMX cable and enable one of the standalone modes on the master unit
(Auto, Color Macro, Static, Tunable White, User Color). Now the slave unit will follow the master unit. If there is no control signal, the display
characters will flash. Flashing stops as soon as a control signal is present.
----------------- Menu ----------------
DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
DEVICE SETTINGS (Settings)
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu item "Settings" (observe arrow) and confirm
with ENTER.
---------------- Menu -----------------
DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
This will take you to the submenu for setting the following submenu items (see table, select with UP and DOWN, confirm with ENTER,
change value or status with UP and DOWN, confirm with ENTER):
Settings
Wireless Setting =
Display Reverse =
Display Backlight =
DMX Fail =
Dimmer Curve =
10
Mode
Slave
W-DMX settings
(Wireless-DMX)
Flip display
Display lighting
Operating status with DMX
signal fault
Dimmer curve
W-DMX On/Off On = W-DMX enabled
Off = W-DMX disabled
Operating Mode Receive = W-DMX module as receiver
Receive = W-DMX module as sender
Transmitting Mode G3 = G3 broadcasting standard
G4S = G4S broadcasting standard
Link Link = pair with W-DMX units. W-DMX must be enabled
on all devices, and the pairing with a transmitter be
retained (Receive Reset).
Unlink = decoupling of all devices
Receive Reset No = Do not retain transmitter pairing
Yes = Retain transmitter pairing
On = rotate display by 180° (e.g. for overhead installation)
Off No display rotation
On On permanently
Off Deactivation after approximately 1 minute of inactivity
Hold Last command is retained
Blackout Activates blackout
Full On All the LEDs are 100%
Stand Alone Spotlight switches to the last selected stand-alone mode
Linear Light intensity increases linearly with DMX value
Exponential Light intensity can be finely adjusted at lower DMX
values and broadly adjusted at higher DMX values
Logarithmic Light intensity can be broadly adjusted at lower DMX
values and finely adjusted at higher DMX values
S-Curve Light intensity can be finely adjusted at lower and
higher DMX values and broadly adjusted at medium
DMX values