Technical Data - Cameo ZENIT W300 Manuel D'utilisation

DMX CABLES
When fabricating your own cables, always observe the illustrations on this page. Never connect the shielding of the cable to the ground
contact of the plug, and always make certain that the shielding does not come into contact with the housing of the XLR plug. If the shielding
is connected to the ground, this can lead to short-circuiting and system malfunctions.
Pin Assignment
DMX cable with 3-pin XLR connectors:
Shield
1
3
2
DMX TERMINATORS (TERMINATING RESISTORS)
To prevent system errors, the last device in a DMX chain needs to be equipped with a terminating resistor (120 ohm, 1/4 Watt).
3-pin XLR connector with a terminating resistor: K3DMXT3
5-pin XLR connector with a terminating resistor: K3DMXT5
Pin Assignment
3-pin XLR connector:
1
3
2
DMX ADAPTER
The combination of DMX devices with 3-pin connectors and DMX devices with 5-pin connectors in a DMX chain is possible with suitable
adapters.
Pin Assignment
DMX Adapter 5-pin XLR male to 3-pin XLR female: K3DGF0020
Pins 4 and 5 are not used.
Pin Assignment
DMX Adapter 3-pin XLR male to 5-pin XLR female: K3DHM0020
Pins 4 and 5 are not used.

TECHNICAL DATA

Product number: CLZW300
Product type: LED wash light
Type: Outdoor floodlight
Color spectrum LED: RGBW
Number of LEDs: 21
LED type: 15 W
LED PWM frequency: 800 Hz, 1200 Hz, 2000 Hz, 3600 Hz, 12 kHz, 25 kHz (adjustable)
Beam angle: 21° (41° Field)
DMX input: 5-pin male XLR, IP65
DMX output: 5-pin female XLR, IP65
DMX modes: 2-channel CCT, 3-channel color macros, 3-channel RGB 8-bit, 4-channel RGBW 8-bit, 6-channel RGB 16-bit,
8-Kanal RGBW 8 Bit, 8-channel RGBW 16-bit, 10-channel full-access 8-bit, and 15-channel full-access 16-bit
DMX control with master/slave mode
DMX functions: Dimmer, fine dimmer, RGBW, RGBW fine, strobe, dimmer curves, color temperature correction, dimming, color
macros, color change, color blending, LED PWM frequency
Standalone functions: Color mixing, color macros, master/slave operation, automatic programmes, strobe, user color, tunable white,
timer function
1
3
2
DMX cable with 5-pin XLR connectors (pin 4 and 5 are not used):
5
4
4
3 3
2
2
1
Shield
5-pin XLR connector:
5
4
3
2
1
5
1
15