W-Dmx™ Status - Cameo ZENIT B200 Manuel D'utilisation

W-DMX™ STATUS
W-DMX™ W-DMX™
as receiver
deactivated
activated,
not coupled
SETTING DMX START ADDRESS (DMX ADDRESS)
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu item "DMX address" (observe arrow) and
confirm with ENTER. The display will show a three-digit number field and you can use the UP and DOWN controls to configure the desired
DMX start address. Confirm the entry with ENTER and press MODE to return to the main display (in the example, "DMX address 001").
---------------- Menu ----------------
DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
CONFIGURING DMX MODE (DMX Mode)
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu item "DMX Mode" (observe arrow) and
confirm with ENTER. In the sub-menu, you can now select between eight different DMX operating modes with the UP and DOWN buttons.
Confirm your selection with ENTER. Tables with the channel assignments can be found in these instructions under DMX CONTROL.
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
W-DMX™ W-DMX
as receiver activated and
activated and coupled device,
device coupled, no DMX signal
Transmitter off,
or out of range
001
–
DMX Address
5xx
001
------------ DMX MODE ------------
15CH Full Access
10CH Full Access
8CH User-Calibrated
6CH Factory-Calibrated
4CH User-Calibrated
3CH Factory-Calibrated
3CH Color Macro
2CH CCT Factory-Calib
W-DMX™ W-DMX™
as reveicer and transmissi-
activated and on mode G3
coupled device, Arrow up = send
DMX signal is operation
present Down arrow =
Receive mode
Arrow flashing =
Coupling
Flashing stops =
Coupled
G3 G4S
W-DMX™
and transmissi-
on mode G4S
Arrow up = send
operation
Down arrow =
Receive mode
Arrow flashing =
Coupling
Flashing stops =
coupled
9