Connections, Operating And Display Elements - Cameo ZENIT B200 Manuel D'utilisation

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

1 4
1
POWER IN
IP65 power input socket with rubber sealing cap. Operating voltage 100 - 240 V AC / 50 - 60Hz. Connection via supplied power cable (when
not in use, always close with rubber sealing cap).
2
POWER OUT
IP65 power output socket with rubber sealing cap. Facilitates power supply to other CAMEO lights. Ensure that the total current consumption of all
connected devices does not exceed the value specified on the device in amperes (A) (when not in use, always close with the rubber sealing cap).
3
ON/OFF
Ensure that the battery is charged sufficiently or connect the lights correctly to the power supply. Move the switch to the down position to
make the floodlight ready for operation. During the start-up process, "Welcome to Cameo", the model name and the software version will be
shown consecutively on the display. When the switch is not in the down position, the floodlight is in standby mode. In both operating states,
the battery is constantly being charged, as long as the floodlight is connected to the power supply correctly.
4
DMX IN
Male IP65 5-pin XLR socket for connecting a DMX control device (e.g. DMX console. When not in use, always close with the rubber sealing
cap).
5
DMX OUT
Female IP65 5-pin XLR socket for sending DMX control signal (when not in use, always close with the rubber sealing cap).
6
OLED DISPLAY
Shows current operating mode, charging status of the battery and the menu items in the edit menu.
7
TOUCH-SENSITIVE CONTROLS
MODE – Press mode to access the selection menu for system settings. Press repeatedly to go back to the main display.
ENTER – Press ENTER to access the menu levels to make value changes, and to access the sub-menus. Confirm value changes by pressing
ENTER.
UP and DOWN – Select individual menu items in the selection menu (DMX address, operating mode etc.) and in the sub-menus. Allow changes to
the value of a menu item, such as the DMX address as required.
PRESSURE EQUALISATION ELEMENT
The pressure compensation element to prevent condensation forming inside the housing is located in the base of the device behind the
cable feed to the LED unit. In order to ensure its proper function, the element must be protected from contamination.
6
7
3
6
7
5 2