Operation - Cameo 4 HEAD MOVING BAR HYDRABEAM 4000 Manuel D'utilisation

OPERATION

NOTE
When the lamp is correctly connected to the mains supply and the standby switch is on, the CAMEO logo is shown on the display during
start-up and motor reset. Once this process is complete, the spotlight is ready for operation and the previously selected operating mode is
activated.
CONFIGURE DMX START ADDRESS
Press MENU to access the selection menu for system settings. Select the menu item "DMX Address" (shaded in colour) using UP and DOWN
and confirm with ENTER. A number field is now displayed and you can set the DMX start address as required, from 001 to 512, using the
UP and DOWN buttons (hold down the button to change values quickly). Confirm with ENTER and press MENU to return to the main display.
After approx. one minute of no input, the main display is automatically activated, the DMX start address is shown clearly at the centre of the
display and the DMX mode appears in the bottom line (6Ch, 10Ch, 19Ch, 32Ch, 56Ch).
CONFIGURE DMX MODE
Press MENU to access the selection menu for system settings. Select the menu item "DMX Mode" (shaded in colour) using UP and DOWN
and confirm with ENTER. A selection field is then displayed and you can set the desired DMX mode using the UP and DOWN buttons.
Confirm with ENTER and press MENU to return to the main display. After approx. one minute of no input, the main display is automatically
activated, the DMX start address is shown clearly at the centre of the display and the DMX mode appears in the bottom line (6Ch, 10Ch,
19Ch, 32Ch, 56Ch).
CONFIGURE AUTO MODE
The 17 available auto programmes each consist of a series of non-editable colour-change and motion sequences. Press MENU to access
the selection menu for system settings. Select the menu item "Auto Mode" (shaded in colour) using UP and DOWN, and confirm with ENTER.
Select the menu item "Show Mode" using the UP and DOWN buttons, confirm with ENTER, then select the required programme, Auto0 to
Auto16, using UP and DOWN again, then confirm with ENTER. You can set the programme speed by selecting the menu item "Show Speed"
using the UP and DOWN buttons, confirming with enter and then using UP and DOWN once again to select a value between 01 and 99 (hold
button down to change values quickly, 01 = minimum and 99 = maximum speed). Confirm with ENTER and press MENU twice to return
to the main display. After approx. one minute of no input, the main display is automatically activated and the selected auto programme is
shown clearly at the centre of the display.
6