Installation - Cameo 4 HEAD MOVING BAR HYDRABEAM 4000 Manuel D'utilisation

Advanced Settings
Reset = Reset motors
Pan Invert = Head1 pan direction
Head2 pan direction
Head3 pan direction
Head4 pan direction
Tilt Invert = Head1 tilt direction
Head2 tilt direction
Head3 tilt direction
Head4 tilt direction
Display = Display lighting
Display invert = Rotate display
DMX Fail = Operating status with
DMX signal fault
Software = Display device software

INSTALLATION

Thanks to its integrated rubber feet, the spotlight can be positioned in a suitable location on the stage floor etc.
Installation on a traverse is possible using the two Omega brackets supplied (only use original accessories) together with the appropriate
traverse clamps (not included). Attach the device securely at the specified position using a suitable safety cable.
Important: Overhead installation may only be carried out by qualified personnel.
Installation on a suitable tripod is possible using the integrated 35 mm tripod flange.
8
Yes. Reset pan and tilt motors
No = Discontinue pan and tilt motor reset
No = No reversal of pan direction
= Reversal of pan direction
Yes.
No = No reversal of tilt direction
= Reversal of tilt direction
Yes.
On = Permanently on
Off = Deactivation after one minute of inactivity
On = Rotate display by 180°
(e.g. for overhead installation)
Off = No display rotation
Auto = Activates auto mode
Black = Activates blackout
Hold = Last command is retained
ENTER V1.x