Installation; Install/Remove Accessories - Cameo F1 T Manuel D'utilisation

SETUP AND INSTALLATION
Thanks to its four plastic feet, the spotlight can be placed in a suitable location on a flat surface. Install on a crossbeam using the prein-
stalled mounting bracket (A) and a suitable crossbeam clamp (available as an accessory). Make sure that the spotlight is firmly attached and
secure it using a suitable safety cable on the designated location on the
top of the spotlight (B). The laterally mounted level screw (C) is used to configure the vertical beam angle.A distance of at least 0.1 meters
must be kept between objects or walls located adjacent, above, or behind the spotlight; a distance of at least 0.5 meters must be kept in
front of the spotlight in the cone of light.
WARNING: Overhead installation requires extensive experience, including the calculation of the load limit values of the
installation material and regular safety inspection of all installation materials and spotlights. If you do not have these
qualifications, do not attempt to carry out the installation yourself; contact a professional company. There is a risk that
incorrectly mounted or secured devices may come loose and fall down. This may lead to serious injury and even fatalities.
A

INSTALL/REMOVE ACCESSORIES

To install or remove the barn doors and the filter frame, please push the spring-loaded locking pin (D) of the retaining bracket so that it folds
upwards. Do not forget afterwards to return the retaining bracket back to the original position so that the locking pins click back into their
locked position.
D
WARNING:
For safety reasons, the filter frame must always be in the respective retaining bracket on
the spotlight, even if no filter is inserted!
WARNING:
Always secure the filter frame, and the barn door if used, to the spotlight using the enclosed safety cable!
10
B