Installation - Cameo NANO ROLL 100 Manuel D'utilisation

SYSTEM SETTINGS AND SYSTEM INFORMATION
To adjust system settings and access system information, press MODE repeatedly until the display shows "SEtt". Confirm by pressing
ENTER. You can now use UP and DOWN to select and edit one of the following menu items:
-> ENTER ->
UP/DOWN
<- MODE

INSTALLATION

The device can be mounted to a traverse using the adjustable mounting bracket and a suitable traverse clamp (not supplied). Secure the
device to the safety eyelet using a suitable safety rope (A). Note: Overhead installation must be carried out by qualified personnel only.
-> ENTER ->
UP/DOWN
<- MODE
The display is
rotated by 180°
(overhead installation)
-> ENTER ->
UP/DOWN
<- MODE
on = display permanently on
off = display goes out after
about 60 seconds of inactivity
-> ENTER ->
UP/DOWN
<- MODE
Reverse PAN direction
-> ENTER ->
UP/DOWN
<- MODE
Reverse rotation direction
-> ENTER ->
UP/DOWN
<- MODE
You can use this menu point to define
which operating mode is enabled
if the DMX signal is interrupted
when in DMX-mode.
-> ENTER
<- MODE
Restore
factory settings
-> ENTER
<- MODE
Displays firmware
version
/
/
/
/
/
Last DMX command Blackout
is retained
A
-> ENTER
-> ENTER
-> ENTER
-> ENTER
/
-> ENTER
Auto programme
7