Settings And Menu - Cameo XNODE 8 Manuel D'utilisation

RJ45 CONNECTORS
Pin Connection
1 Data +
2 Data -
3 Not connected
4 Not connected
5 Not connected
6 Not connected
7 Com
8 Com
Shield Earth
Each port is individually optically isolated.

SETTINGS AND MENU

GENERAL NAVIGATION
The encoder wheel is the primary means for navigating through the menus. Most of the menus arrange items vertically. In those menus,
turn the encoder clockwise to select the item below the currently selected item or turn the encoder counter clockwise to select the item
above the currently selected item. In menus that arrange items horizontally (e.g. text fields), clockwise means "to the right" and counter
clockwise means "to the left".
Other than that, the encoder wheel also functions as a push button. This button is generally used to confirm a selection or to navigate to a
selected submenu. This manual will also refer to pushing the encoder knob as "push [OK]" or "push the [OK] button".
On the right side of the encoder knob, you can find the [Cancel] button, which is generally used to dismiss a selection or to exit a menu.
By keeping the [Cancel] button pressed for at least two seconds, you can always navigate to the Home Screen. From the Home Screen, the
menu is launched by simply pushing the [OK] button.
The following notation is used to describe locations in the menu: Home > Menu > Sub menu > ...
For example, the manual could say "navigate to Home > Menu > Art-Net". This can be read as follows:
Keep [Cancel] pressed for 2 seconds to reach the Home Screen.
Then, press [OK] to get to the menu.
Select Art-Net using the encoder wheel.
After pressing [OK] again to confirm the selection, a choice of the two (virtual) Art-Net nodes is displayed. XNODE 8 has two conceptual
Art-Net nodes when the node is not operating in Art-Net 4 mode. This is because the number of Art-Net ports per node is limited to four by
the Art-Net I, II and 3 specifications.
7