Publicité
Les langues disponibles
Les langues disponibles
Process transmitter
5.5 Operating parameters
arameter
User code
User presettable
operation code
An already set code can only
be changed if the old code is
first entered and the unit
setting up released. Then a
new code can be set up.
* Set point code
Set point changes require
or do not require a user
defined release code
This address is only active when a user defined operation code is set up
rogramme name
Display address:
Display of the software
used in the unit
Software version
Display address:
Display of the version
number of the software
used
* Time trend
monitor
The preset time value for
the trend monitor
This address is only available if the alarm set point option is active!
64
Setting up selections
CODE
Value:
0000 to 9999
There is no operation
code active if “0" is set
LICOD
YES
Set points are user code
protected
NO
Set points can be
changed without setting a
user defined code
PNAME
SU-ID
TRDT
Value:
10
10 seconds
60
1 minute
600
10 minutes
PARAM
Default
Actual
settings
setting
0
YES
10
Publicité
