Commissioning As A Position Controller; Basic Configuration; Operating Mode For Basic Configuration - Burkert 8630 Instructions De Service

6.3

Commissioning as a position controller

Follow the pneumatic and electrical connection instructions before commissioning (chapter 5).

6.3.1 Basic configuration

Select the following basic configuration for the initial commissioning :
• Enter the displacement range of the pneumatic actuator.
• Enter the unit of the selected input signal (4..20 mA, 0..20 mA, 0..10 V or 0..5 V).
Start the self-calibration of the Top Control Continuous to the selected operating conditions(Autotune).
•

6.3.2 Operating mode for basic configuration

Assignment of the keys:
MANUAL/AUTOMATIC key
Arrow keys
118
Changing between main- and submenu
SNGL
e. g.
Changing between same level functions
e. g.
Operating instructions no. 800607