Control Panel - Husqvarna AUTOMOWER 430XH Manuel D'utilisation

Low-voltage cables of different lengths are
available as accessories.
WARNING: Do not under any
circumstances mount the power supply
at a height where there is a risk it can
be submerged in water (at minimum 30
cm / 12" from the ground). It is not
permitted to place the power supply on
the ground.
min 30 cm / 12"
WARNING: Use the plug to disconnect
the charging station, for instance
before cleaning the charging station or
repairing the loop wire.
WARNING: Place the low voltage
cable and adjust the cutting height so
that the blades on the blade disc can
never come in contact with the cable.
WARNING: To reduce the risk of
damage to electrical components,
disconnect all connections to the
charging station (power supply,
boundary wire and guide wires) if there
is a risk of a thunderstorm.
For more instructions on how to do a proper
installation, refer to chapter
complete Operator's manual on Husqvarna's
website www.husqvarna.com.

3.2 Control panel

All commands and settings for the product are
made via the control panel. All functions are
accessed via a number of menus.
The control panel consists of a display and a
keypad. All information is shown on the display
and all input is done using the buttons.
10 - Installation
Installation in the
Note: The display texts are shown in English in
the manual, but you will see the texts on the
product display in the chosen language.
3.3 Display
When the STOP button has been pressed and
the hatch is opened, the following information is
displayed:
• Operating information, e.g.
MOWING , PARKED or TIMER . READY is
displayed if the product is not in any specific
operating mode, e.g. if the main switch has
just been turned on. If the STOP button is
pressed the product displays what it did prior
MOWING or SEARCHING .
to the stop, e.g.
• Date and clock show the current time.
• The satellite symbol is shown when the
GPS-supported navigation is activated.
Symbol (A) is shown when the symbol has
made contact with a sufficient number of
GPS satellites. Symbol (B) shows when the
product has not made contact with a
sufficient number of GPS satellites. Symbol
(A) blinks during the first days the product is
working, as it is collecting GPS information
about the installation.
A
• The ECO symbol is displayed if the product
ECO mode .
is set in
• The black clock symbol (A) is shown when
the product is not allowed to mow due to a
timer setting. If the product is not allowed to
Weather timer , symbol (B) is
mow due to
shown. If the operation mode
is chosen, symbol (C) is shown.
READY ,
B
Override timer
1039 - 001 - 18.01.2019