Troubleshooting; Battery Charger; Control Panel - Husqvarna LB 548i Manuel D'utilisation

To examine the cutting equipment
WARNING: To prevent accidental start, pull
up the safety key, remove the battery and
wait a minimum 5 seconds.
WARNING: Use protective gloves when you
do maintenance on the cutting equipment.
The blade is very sharp and cuts can easily
occur.
Battery
LED on the battery
The green LED is flash-
ing
The error LED flashes
The error LED is on

Battery charger

LED on the battery
charger
The error LED flash-
es
The error LED is on

Control panel

Error code (Number
of flashes)
1
5
8
24

Troubleshooting

Possible faults
The battery voltage is low
The battery is weak
The temperature in the work environ-
ment is too high or too low
Overvoltage
Cell difference too much (1V)
Possible faults
The temperature in the work en-
vironment is too high or too low
Possible faults
The transmission motor is too hot.
The motor speed decreases too much, and
the motor stops.
The battery is weak.
1. Examine the cutting equipment for damage or
cracks. Always replace a damaged cutting
equipment.
2. Look at the blade to see if it is damaged or blunt.
Note: It is necessary to balance the blade after it is
sharpened. Let a service center sharpen, replace and
balance the blade. If you hit an obstacle that causes the
product to stop, replace the damaged blade. Let the
service center estimate if the blade can be sharpened or
must be replaced.
Possible procedure
Charge the battery. See
page 21 .
Charge the battery. See
Use the battery in temperatures between -10°C
and 40°C.
Check that the mains voltage is the same as on
the rating plate on the product.
Remove the battery from the battery charger. Wait
5 seconds and try again to charge the battery. If
the problem continues, speak to an authorised
service agent.
Speak to an approved service agent.
Possible procedure
Use the battery charger in temperatures between 5°C
and 40°C.
Speak to an approved service agent
Possible procedure
Let the product become cool. Make sure that
the transmission does not have grass on it.
Clean the transmission cover if it is necessa-
ry.
Clean the cutting deck and increase the cut-
ting height. Refer to
on page 20 . If the error stays, speak to your
approved service agent.
Charge the battery. Refer to
battery on page 21 .
To charge the battery on
Battery on page 24 .
To set the cutting height
To charge the
1336 - 003 - 17.12.2019