Browse Between Menus; Menu Structure - Husqvarna AUTOMOWER 430XH Manuel D'utilisation

A B
• The battery status shows the remaining
battery charge. If the product is loading, a
flash is also shown over the battery symbol
(A). If the product is placed in the charging
station without charging, (B) is shown.
A
• The height adjustment setting is displayed
as a scale/numerical value.
3.4 Keypad
The keypad consists of 6 groups of buttons:
• The START button is used to activate the
product. This is normally the last button to
be pressed before closing the hatch.
• The BACK and OK buttons are used to
navigate in the menu. The OK button is also
used to confirm settings.
• The arrow keys are used to navigate in the
menu but also to make selections in certain
setting options.
• The MENU button is used to go to the main
menu.
• The PARK button is used to send the
product to the charging station.
• The number keys are used to enter
settings, for example PIN code, time or exit
direction.

3.5 Menu structure

The main menu for the product offers 8 options.
3.6 Submenus
There are a number of submenus under each
option. You can access all the functions to set the
product settings via the submenus.
1039 - 001 - 18.01.2019
Certain submenus contain options that are ticked
C
off to the left. This means that these options are
selected. Check or uncheck the box by pressing
the OK button.

3.7 Browse between menus

Browse through the main menu and submenus
with the help of the arrow keys. Enter values and
times using the number keys and confirm each
selection with the OK button. Press BACK to go
up a step in the menu or keep the MENU button
pressed in for 2 seconds to go directly to the
B
main menu.
3.8 Main menu
Timer
The lawn should not be cut too often to
obtain the best mowing result.
Consequently, it is important to limit
the operating time using the timer
function if the work area is less than
the product's work capacity. The timer
function is also an ideal tool to control
which periods the product should not
mow, for example when children are
playing on the lawn.
Cutting height
The cutting height can be varied from
MIN (1) to MAX (9). During the first
week after a new installation, the
cutting height must be set to MAX to
avoid damaging the loop wire. After
this, the cutting height can be lowered
one step every week until the desired
cutting height has been reached.
Security
In this menu, settings relating to
security and the connection between
the product and the charging station
can be made. There are 3 security
Low , Medium ,
levels to choose from:
High .
Messages
Historical fault and information
messages can be read in this menu.
Installation - 11