Operation - Husqvarna AUTOMOWER 430XH Manuel D'utilisation

For some of the most common fault
messages, there are tips and advice to
help you rectify the fault.
Weather timer
This function allows the product to
automatically adjust its mowing times
based on how much the lawn grows.
When the weather is good for grass
growth, the product mows more often
and when grass growth is low the
product automatically spends less time
on the lawn.
Installation
This menu function is used to
customize the installation. For many
work areas there is no need to alter the
factory settings, but depending on the
lawn complexity the mowing result can
4.1 Operation selection START
When the START button has been pressed the
following operation selections can be selected:
MAIN AREA . The standard operating mode
•
where the product mows and charges
automatically.
SECONDARY AREA . When mowing
•
secondary areas this setting must be
chosen.
If the product charges in the
mode, it will fully charge, drive out about 50
cm / 20 in. and then stop. This indicates that
it is charged and ready to start mowing. If
the main work area has to be cut after
charging, it is appropriate to switch the
operation selection to
placing the product in the charging station.

12 - Operation

4 Operation
Secondary area
Main area before
be improved by making manual
settings.
Settings
This selection allows you to make
changes to the general product
settings such as date and time. You
can also turn on/off
Spiral cutting , or save your settings in
Profiles . Husqvarna
different
recommends to let
turned on to save energy and avoid
interference with other equipment.
Accessories
This menu handles the settings for the
product accessories, for examples
Automower Connect. Contact your
local Husqvarna representative for
information on what accessories are
available for your product.
OVERRIDE TIMER . Any timer settings
•
made can be temporarily overridden by
selecting Override timer. It is possible to
override the timer for 24 h or 3 days.
SPOT CUTTING . The product works in a
•
spiral pattern to cut the grass where it has
been mown less than in other parts of the
lawn.
Spot Cutting function is activated with
The
the START button. You can select how the
product should continue to work once
mowing is finished by pressing right arrow
Main Area or Secondary
and then specifying
Area .
4.2 Operation selection PARK
When the PARK button is pressed the following
operation selections can be chosen.
ECO mode and
ECO mode be
1039 - 001 - 18.01.2019