Symbols On The Product - Husqvarna AUTOMOWER 430XH Manuel D'utilisation

29. Couplers for the loop wire
30. Loop wire for boundary loop and guide wire
2
3
31. Stakes
32. Connectors for the loop wire

1.8 Symbols on the product

These symbols can be found on the product.
Study them carefully.
WARNING: Read the
user instructions before
operating the product.
WARNING: Operate the
disabling device before
working on or lifting the
machine.
The product can only start
when the main switch is
set to
PIN code has been en-
tered. Turn the main
switch to
ing out any inspections
and/or maintenance.
WARNING: Keep a safe
distance from the ma-
chine when operating.
Keep your hands and feet
away from the rotating
blades.
WARNING: Do not ride
on the machine. Never
put your hands or feet
close to or under the ma-
chine.
Never use a high-pres-
sure washer or even run-
ning water to clean the
product.
This product conforms to the
applicable EC Directives.
1
Is a part of the Installation kit which is purchased separately.
2
See note 1
3
See note 1
4
See note 1
1039 - 001 - 18.01.2019
1
4
1 and the correct
0 before carry-
1.9 Battery symbols
Noise emission to surroundings. The
product's emissions are set out in
Technical data on page 18 and on the
rating plate.
It is not permitted to dispose this
product as normal household waste.
Ensure that the product is recycled in
accordance with local legal
requirements.
The chassis contains components
which are sensitive to electrostatic
discharge (ESD). The chassis must
also be resealed in a professional
manner. For these reasons the chassis
shall only be opened by authorized
service technicians. A broken seal can
result in the entire or parts of the
guarantee no longer being valid.
The low voltage cable must not be
shortened, extended or spliced.
Do not use a trimmer nearby the low
voltage cable. Be careful when
trimming edges where the cables are
placed.
Operate the disabling device before
you use or lift the product.
Read the user instructions.
Do not discard the battery into fire and
do not expose the battery to a heat
source.
Do not immerse the battery into water.
Introduction - 5