Battery Charger; Control Panel; Transportation, Storage And Disposal - Husqvarna LC 247i Manuel D'utilisation

Battery charger

LED on the battery
charger
The error LED flash-
es
The error LED is on

Control panel

Keypad Error code (Num-
ber of flashes)
Error LED flashes 3
5
10
2
9
The product stops 8
0
Other errors If other errors occur, turn the safety key to 0, remove the battery and speak to an approved
service agent.
Introduction
WARNING:
start during transport turn the safety key
to "0", remove the battery and wait at least 5
seconds.
To set the product in transport position
1. Loosen the lower knobs.
1199 - 005 - 09.12.2020
Possible faults
The temperature in the work en-
vironment is too high or too low
Possible faults
The motor is overloaded
The motor speed drops too
much, and the motor stops
The motor control is too hot
The blade is blocked
Battery error or no signal from
battery
The battery is weak
Battery connector failure

Transportation, storage and disposal

To prevent unintentional
Possible procedure
Use the battery charger in temperatures between 5°C
and 40°C.
Speak to an approved service agent
Possible action
Increase the cutting height. Refer to
set the cutting height on page 15 .
Stop the motor and wait until it has be-
come cool
To prevent accidental start turn the safe-
ty key to 0, remove the battery and wait
a minimum 5 seconds. Make sure that
the blade can rotate freely. If the prob-
lem continues, speak to an authorised
service agent
Put the battery in the product correctly
and examine the battery connector. If the
error LED on the battery flashes. Refer
Battery on page 15 .
to
Charge the battery. Refer to
the battery on page 16 .
Examine the battery connector
2. Move the knobs to the lower end of the grooves on
the left and the right side of the product.
To
To charge
21