Troubleshooting - Husqvarna LC 247i Manuel D'utilisation

6. When you attach the new blade, point the angled
ends of the blade in the direction of the cutting cover.
7. Make sure that the blade is aligned with the center of
the motor shaft.
8. Lock the blade with a block of wood. Attach the
spring washer and tighten the bolt and washer with a
torque of 23–28 Nm.
Battery
LED on the battery
The green LED is flash-
ing
The error LED flashes
The error LED is on
20

Troubleshooting

Possible faults
The battery voltage is low
The battery is weak
The temperature in the work environ-
ment is too high or too low
Overvoltage
Cell difference too much (1V)
9. Pull the blade around by hand and make sure that it
turns freely.
WARNING:
The blade is very sharp and cuts can
easily occur.
10. Start the product to do a test of the blade. If the
blade is not correctly attached, there is vibration in
the product or the cutting result is unsatisfactory.
Possible procedure
Charge the battery. See
page 16 .
Charge the battery. See
Use the battery in temperatures between -10°C
and 40°C.
Check that the mains voltage is the same as on
the rating plate on the product.
Remove the battery from the battery charger. Wait
5 seconds and try again to charge the battery. If
the problem continues, speak to an authorised
service agent.
Speak to an approved service agent.
Use heavy duty gloves.
To charge the battery on
Battery on page 20 .
1199 - 005 - 09.12.2020