Husqvarna LC 247i Manuel D'utilisation page 17

6. Loosen the start inhibitor.
7. Push the motor brake handle in the direction of the
handlebar.
To use the drive on the wheels
LC 347iV, LC 347iVX, LC 353iV,
LC 353iVX
• Pull the drive bail in the direction of the handlebar to
start the drive.
• Push + and - on the control panel to set the drive
speed in 4 steps.
• Release the drive bail to disengage the drive, for
example when you go near an obstacle.
1199 - 005 - 09.12.2020
To use the function
The product has a battery saving function () that gives
longer operation time.
1. Push the button (A) to start the function. The symbol
(B) on the display comes on.
2. Push the button again to stop the function. The
symbol (B) on the display goes out.
The function stops automatically if the ground conditions
make it necessary to have a higher output. The function
starts automatically again when the ground conditions
let it.
High load function
When the product cuts long or wet grass, the motor
automatically increases rpm. The motor goes back to
standard mode when high load is not necessary.
To stop the product
The product stops automatically if you do not operate it
for 10 minutes. Always turn the safety key to 0 before
you let the product out of view.
1. Release the motor brake handle to stop the motor.
2. Push the ON/OFF button on the control panel. All
LED lights and symbols on the display go out.
B
A
17