Battery Charger; Control Panel; Transportation, Storage And Disposal - Husqvarna LC 141iV Manuel D'utilisation

Battery charger

LED on the battery
charger
The error LED flash-
es.
The error LED is on.

Control panel

For problems, other than those in this section, speak to
your service agent.
Keypad
Error LED flashes
The product stops
To set the product in transport position
1. Remove the grass catcher (if installed).
919 - 010 -
Cause
The temperature in the work en-
vironment is too high or too low.
Possible faults
The motor is overloaded
The motor speed drops too much,
and the motor stops
The motor control is too hot
The blade is blocked
Battery error or no signal from battery Put the battery in the product correctly and exam-
The battery is weak
Battery connector failure

Transportation, storage and disposal

Solution
Use the battery charger in temperatures between 5°C
and 40°C.
Speak to an approved service agent.
Possible action
Increase the cutting height. See
height on page 16 .
Stop the motor and wait until it has become cool
To prevent accidental start turn the safety key to
0, remove the battery and wait a minimum 5 sec-
onds. Make sure that the blade can rotate freely. If
the problem continues, speak to an authorised
service agent
ine the battery connector. If the error LED on the
battery flashes, see
Charge the battery. See
page 16 .
Examine the battery connector
2. Loosen the knobs on the upper handle and fold the
handle down.
To set the cutting
Battery on page 22 .
To charge the battery on
23