Maintenance; Maintenance Schedule - Husqvarna LC 141iV Manuel D'utilisation

To stop the product
1. Release the motor brake handle to stop the motor.
2. Disconnect the power cord from the mains and then
from the product.
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
LC 141iV, LC 141i and LC 141C
Do a general inspection.
Clean the product.
Do a check of the start inhibitor *.
Make sure that the safety devices on the product are not defective *.
Examine the cutting equipment.
Examine the cutting cover *.
Do a check of the motor brake handle *.
20

Maintenance

Before you do
CAUTION:
out. Do not pull the power cord.
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
service agent, speak to them for information about the
nearest service agent.

Maintenance schedule

The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with *, refer to
on the product on page 9 .
Each use
Pull the plug straight
Safety devices
Each
Monthly
season
X
X
X
X
X
X
X
919 - 010 -