B.Braun Aesculap Acculan 4 Mode D'emploi page 14

Aesculap
Dermatome GA340 / Dermatome 0.1 mm GA341
7.9 Automatic cleaning/disinfection with manual pre-cleaning
Note
The cleaning and disinfection device must fundamentally have a tested
efficacy (such as FDA approval or CE label pursuant to DIN EN ISO 15883).
7.9.1 Manual pre-cleaning with a brush
Phase Step
I Rinsing
II Brushes
D–W: Drinking water
RT: Room temperature
►
Do not clean the product in a ultrasonic bath and do not immerse the
product in any fluids. Let any fluid incursions drain out immediately,
otherwise there is a danger of corrosion and loss of function.
Phase I
►
Dismantle the flap rod for cleaning. Store flap rods, flaps and nut sep-
arately in tray.
►
Mobilize non-rigid components during cleaning.
►
Thoroughly clean the product under running water.
7.9.2 Mechanical alkaline cleaning and thermal disinfection
Machine type: single-chamber cleaning/disinfection device without ultrasound
Phase Step
I Pre-rinse
II Cleaning
III Intermediate rinse
IV Thermal disinfection
V Drying
D–W: Drinking water
FD–W: Fully desalinated water (demineralized, low microbiological contamination: drinking water quality at least)
*Recommended: BBraun Helimatic Cleaner alkaline
12
Acculan 4
®
T t
[°C/°F] [min]
RT (cold) -
RT (cold) -
T t
[°C/°F] [min]
<25/77 3
55/131 10
>10/50 1
90/194 5
- -
Note
The cleaning and disinfection machine used for processing must be ser-
viced and checked at regular intervals.
Conc. Water Chemistry/Note
[%] quality
- D–W Until visually clean
- D–W Until visually clean
Phase II
►
Mobilize non-rigid components during cleaning.
►
Brush difficult to access surfaces with a suitable plastic cleaning brush
for at least 1 min.
►
After manual preparation, check visible surfaces for residue and repeat
the pre-cleaning process as needed.
Note
For details on difficult to access surfaces, see Acculan pre-cleaning and
care information TA016000 (available in Aesculap Extranet at
https://extranet.bbraun.com).
Water Chemistry/Note
quality
D–W -
■
FD–W
Concentrate, alkaline:
– pH ~ 13
– <5 % anionic surfactant
■
0.5 % working solution
– pH ~ 11*
FD–W -
FD–W -
- mind. 10 min at max. 120 °C