Stihl ASP 100 Manuel D'utilisation page 36

● RT 4082, RT 5097/ C/ Z, RT 5112 Z,
RT 6112 C/ ZL, RT 6127 ZL:
Remove the mowing deck, grass
catcher box and discharge chute.
(See instruction manual of the ride-on
mower)
● RT 5097/ C/ Z, RT 5112 Z,
RT 6112 C/ ZL, RT 6127 ZL:
Install the cover ( 9.1).
● Prepare the ride-on mower for winter
use. ( 12.)
13.2 Placing the snow plough in
the transport position
● Bring the ride-on mower to a
complete standstill.
(See instruction manual of the ride-on
mower)
● Raise the snow plough. (
13.3 Lowering the snow plough
into the working position
● Bring the ride-on mower to a complete
standstill.
(See instruction manual of the ride-on
mower)
● Lower the snow plough. (
13.4 Swivelling the snow plough
● Bring the ride-on mower to a complete
standstill.
(See instruction manual of the ride-on
mower)
● Raise the snow plough into the
transport position.
● Turn the swivel rod and hold. (
34
● Swivel the snow plough into the desired
position by pulling or pushing the swivel
rod. (
● Release the swivel rod and ensure that
the locking mechanism engages in the
snow plough.
13.5 Snowploughing
Risk of injury!
Clear snow at walking speed only,
never at maximum driving speed.
Prior to ploughing, check the area
to be cleared thoroughly and mark
or remove all protruding obstacles
14
(overhangs, pavement, flagstones,
etc.).
Approach large accumulations of
snow (e.g. already ploughed snow)
at low speed only.
10.1)
Note
Before ploughing, read and
observe the section "Notes on
working with the machine". (
15
Starting (hydrostatic gearbox):
Note
Please see the ride-on mower
instruction manual to determine
whether the mower is equipped
with a hydrostatic or manual
10.1)
gearbox.
● Start the engine.
(See instruction manual of the ride-on
mower)
● If necessary, turn the light on.
(See instruction manual of the ride-on
mower)
● Raise the snow plough into the
transport position. (
10.2)
10.2)
13.2)
● Drive the ride-on mower onto the area
to be cleared.
(See instruction manual of the ride-on
mower)
● Set the throttle lever to the MAX
position. The throttle lever must always
be in the MAX position while clearing
snow.
(See instruction manual of the ride-on
mower)
● Swivel the snow plough into the desired
position. ( 10.2)
● Lower the snow plough into the working
position. ( 13.3)
● Press the drive pedal slowly and
carefully. The ride-on mower starts
moving slowly.
If necessary, increase the driving
speed.
(See instruction manual of the ride-on
mower)
Braking (hydrostatic gearbox):
● Release pressure on the drive pedal
11.)
until the ride-on mower comes to a
standstill.
(See instruction manual of the ride-on
mower)
● Operate the brake as required.
(See instruction manual of the ride-on
mower)
● Place the snow plough in the transport
position if necessary. (
Starting (manual gearbox):
Note
Please see the ride-on mower
instruction manual to determine
whether the mower is equipped
with a hydrostatic or manual
gearbox.
13.2)
0478 907 9930 A - EN