Stihl ASP 100 Manuel D'utilisation page 32

9. Installing and removing
the snow plough
9.1 Installing the cover
Note!
To prevent damage to the
discharge chute when the mowing
deck is not installed, it must be
removed on the models RT 4082,
RT 5097/ C/ Z, RT 5112 Z and
RT 6112 C/ ZL, RT 6127 ZL. When
the discharge chute is not installed,
the cover must be installed as a
safety device.
● RT 4082, RT 5097/ C/ Z, RT 5112 Z
and RT 6112 C/ ZL, RT 6127 ZL:
Remove the discharge chute.
(See instruction manual of the ride-on
mower)
● RT 5097/ C/ Z, RT 5112 Z:
Fit cover (D) onto screws (2) using the
respective inner bores (1). Fasten
cover (D) by turning nuts (3).
● RT 6112 C/ ZL, RT 6127 ZL:
Fit cover (D) onto screws (2) using the
respective outer bores (4). Fasten
cover (D) by turning nuts (3).
30
9.2 Installing the snow plough
Risk of injury!
Do not lift snow plough (A) when
installing it. Take account of the
weight of the snow plough
6
assembly. (
For safety reasons, the snow
plough should only be lifted with the
help of a second person. (
Keep others away from the direct
vicinity when installing the snow
plough.
ASP 125:
Wear work gloves when installing
the snow plough. Danger of burns
due to hot parts (exhaust, etc.) on
the ride-on mower!
● Stop the engine.
(See instruction manual for the ride-on
mower)
● Engage the parking brake.
(See instruction manual for the ride-on
mower)
● Remove the mowing deck. (Follow the
instructions in the instruction manual for
the ride-on mower precisely)
● Install the cover. (
7
21.)
16.1)
9.1)
Hold handle (2) with one hand
when installing the snow plough.
With the other hand, press locking
lever (6).
Danger of burns!
Avoid contact with the hot exhaust
when pressing the locking lever.
The model RT 4082 is an exception
to this. The exhaust is not near the
locking lever on these models.
Danger of pinching!
Do not hold the snow plough at
moving parts during installation.
● Tilt snow plough (A) slightly so that it is
balancing on the two gauge wheels. Lift
snow plough mounting (1) at
handle (2). Push the snow plough
towards mounting bore (3) in mounting
frame (4). Insert stud (5) into mounting
bore (3).
● Push locking lever (6) outwards until
the arrow on the locking lever lines up
with outer marking (A).
● Push snow plough (A) as far as it will go
onto mounting frame (4). Release
locking lever (6) again, making sure it
engages fully. When the locking lever is
engaged, the arrow lines up with inner
marking (B).
● Install the lift rod. ( 9.3)
● Install the swivel rod. (
9.3 Installing the lift rod
● Install the snow plough. (
● Read the section "Adjusting the lift rod"
before installing the lift rod. (
0478 907 9930 A - EN
9.4)
8
9.2)
15.3)