Stihl ASP 100 Manuel D'utilisation page 34

● Install the discharge chute.
(See instruction manual for the ride-on
mower)
10. Controls
10.1 Lift pedal
Danger of crushing!
Only operate the lift pedal from the
driver's seat of the ride-on mower.
Keep others away from the direct
vicinity when lowering the snow
plough.
Only press the lift pedal when the
ride-on mower is at a complete
standstill.
Always counterhold the lift pedal
securely with the foot when
pressing it (lifting or lowering) and
guide it until it reaches the working
position or transport position. Do
not allow the snow plough to fall
abruptly to the ground when
lowering it.
Note!
The following maximum forces can
be required to operate the lift rod
depending on the setting:
ASP 100: 255 N (26 kg)
ASP 125: 294 N (30 kg)
The snow plough has two positions - the
transport position and the working
position.
When the snow plough is in the transport
position, it is raised and is not in contact
with the ground.
When the snow plough is in the working
position, its entire weight is on the ground.
32
The position of the snow plough can be
changed conveniently from the driver's
seat using the lift pedal.
Raising the snow plough:
● Press lift pedal (1) down as far as it will
go with the foot until locating lug (2) of
locking lever (3) engages at stud (4).
Lowering the snow plough:
● Press lift pedal (1) down slightly with
12
the foot, pressing locking lever (3)
forwards as far as it will go with the tip
of the foot and holding.
Slowly guide lift pedal (1) upwards with
the foot until the snow plough is in full
contact with the ground.
Remove foot from lift pedal (1).
10.2 Swivel rod
Danger of crushing!
Only operate the swivel arm
release from the driver's seat of the
ride-on mower.
Keep others away from the direct
vicinity when swivelling the snow
plough.
After the swivel arm release has
been actuated, the snow plough
can be swivelled into 3 positions
with the aid of the swivel rod.
Never actuate the swivel arm
release while clearing snow.
Unload the snow plough before
each actuation by raising it into the
transport position.
Turning swivel rod (1) releases the snow
plough. The snow plough can then be
swivelled.
After swivel rod (1) is released, the snow
plough engages in one of the 3 positions.
The snow plough is locked in place after it
engages.
Releasing and swivelling the snow
plough:
● Turn the swivel rod (1) inwards
(clockwise) at the handle and hold. The
locking mechanism is released and the
snow plough can be swivelled by
pushing or pulling the swivel rod.
Locking the snow plough in place:
● Release swivel rod (1).
When the snow plough is in one of the
3 notched positions, the locking
mechanism engages automatically.
The snow plough is locked in place and
cannot be swivelled until it is released
again.
11. Notes on working with
13
the machine
Warning!
Risk of injury!
Carefully read and observe the
section "For your safety" before
operating the machine. (
Observe all information regarding
safe operation of the machine.
Use of the ride-on mower is not
permitted on public roads.
When clearing snow, the height and
characteristics of the snow (temperature
dependent) must be taken into
consideration.
These two factors have a significant
influence on the clearing performance of
the machine.
4.)
0478 907 9930 A - EN