Stihl ASP 100 Manuel D'utilisation page 33

● Insert lift rod (C) into one of the three
bores in lift arm (1). Insert cotter pin (2)
into the bore in the lift rod.
9.4 Installing the swivel rod
Note!
Cut the cable tie at the bracket
using side cutters and remove
during initial installation – caution:
danger of cuts!
● Install the snow plough. (
● Push swivel rod (I) into ring nut (1) from
above.
● Push swivel rod (I) into bracket (2) and
spring (3) on the snow plough. Attach
release rod (4) to swivel rod (I). Insert
cotter pin (5) through the bore in swivel
rod (I).
9.5 Removing the snow plough
Risk of injury!
Do not lift the snow plough when
removing it. Take account of the
weight of the snow plough
assembly. ( 21.)
For safety reasons, the snow
plough should only be lifted with the
help of a second person. (
Keep others away from the direct
vicinity when removing the snow
plough.
ASP 125:
Wear work gloves when removing
the snow plough. Danger of burns
due to hot parts (exhaust, etc.) on
the ride-on mower!
0478 907 9930 A - EN
● Stop the engine.
(See instruction manual for the ride-on
mower)
● Engage the parking brake.
(See instruction manual for the ride-on
mower)
9
● Swivel the snow plough to the central
position. (
● Lower the snow plough into the working
position. (
Step 1
Removing the swivel rod:
9.2)
● Detach the swivel rod at the snow
plough:
Pull out cotter pin (1) at swivel rod (2),
remove release rod (3) from the swivel
rod and place to one side. Pull swivel
rod (2) out from spring (4) and
bracket (5).
● Remove the swivel rod at the frame:
Pull swivel rod (2) out from ring nut (6)
upwards.
Step 2
10
Detaching the lift rod:
● Pull out cotter pin (7) at lift rod (8).
Detach lift rod (8) from lift arm (9). Turn
lift rod (8) forwards and lean against the
snow plough.
Step 3
Removing the snow plough:
16.1)
13.4)
13.3)
Hold the snow plough at
handle (10) with one hand when
removing it. With the other hand,
press locking lever (11).
Risk of injury!
Avoid contact with the hot exhaust
and the surrounding parts when
pressing the locking lever. The
model RT 4082 is an exception to
this. The exhaust is not near the
locking lever on these models.
Danger of pinching!
Do not hold the snow plough at
moving parts during removal.
● Pull locking lever (11) outwards as far
as marking (A) and hold. Pull snow
plough (12) forwards until stud (13) is
freely accessible.
● Release locking lever (11) again.
Avoid damage to the machine!
When installing the mowing deck,
always remove the cover and install
the discharge chute. The mowing
deck must only be used with the
discharge chute installed.
9.6 Removing the cover
Note
On the models RT 5097/ C/ Z,
RT 5112 Z, RT 6112 C/ ZL,
RT 6127 ZL, the discharge chute
must be installed after the cover is
removed.
● Unscrew and remove nuts (1).
● Detach and remove cover (2) from
bolts (3).
11
31