Proper Use; Non-Approved Use - BelFox 47-21-0 Instructions D'installation

Due to the wide range of setting options, settings can also be made in relation
to the driven systems that are obviously illogical, impermissible or even dan-
gerous. This is not a fault or defect in the control system. The installer / person
responsible for the system must carefully check the settings made in this re-
spect and change them if necessary.

2.3. Proper use

This motor control unit is constructed for use with a BELFOX gate drive.
Reliable operation is only ensured if the device is installed carefully in accord-
ance with these instructions.
Observe the manufacturer's specifications regarding the gate drive, consisting
of gate and drive. You can avoid possible dangers in the sense of EN 13241-1 if
the assembly follows the specifications of these instructions.
Gates operated by a drive must comply with the valid standards.
The gate must run smoothly so that the safety shutdown can react optimally.
The gate must have a mechanical end stop in the open and closed position,
otherwise it can be pushed out of the guide when it is in the "emergency un-
locked" state.
Gates located in the public area and equipped only with a safety device, e.g.
force limiter, may be operated only under supervision.

2.4. Non-approved use

The product may only be used for the purpose intended by the manufacturer.
Any other use is to be considered improper and therefore dangerous. We can-
not provide a guarantee or warranty for damage caused by other uses or by
incorrect assembly, and we are not liable for this either.
Non-intended modifications, additions and/or conversions to the actuator or
the controls can lead to unforeseeable dangers.
7