BelFox 47-21-0 Instructions D'installation page 49

The force requirement of the gate was determined during the learning runs.
A reserve was added to this force requirement. If the reserve is not sufficient,
you can increase the value in both directions at the two potentiometers "Force
open" and "Force closed".
1 1 0 0 . . A A n n t t e e n n n n a a c c o o n n n n e e c c t t i i o o n n
The rod antenna should be assembled at the highest possible position, an as-
sembly in the radio shadow is to be avoided!
In the terminal 6, in the screw terminal connection on the board is connected a
throw antenna. In order to achieve an optimum range, this must be led out of
the housing.
Alternatively, the core of a rod antenna can be connected to terminal 6.
The shielding must not be connected to terminal 7.
1 1 1 1 . . T T e e a a c c h h i i n n g g - - i i n n o o f f t t h h e e r r a a d d i i o o c c o o d d e e s s
DIP switches on the motor control are only for program selection, NO radio
coding!
In the handheld transmitters, all dip switches are set to OFF or ON. This means
that each handheld transmitter has its own individual security code. You can
teach this safety code into the motor control unit. Up to 49 codes can be taught
in. You can also set a code by setting four of the ten dip switches in the hand-
held transmitter to ON. In this way, you have the same coding for all handheld
transmitters on a particular system.
To teach in the coding, press the "Radio" key on the motor control unit for ap-
prox. half a second. The yellow LED starts to flash once at intervals of 2 sec-
onds. You now have approx. 15 seconds to program the desired key of the
handheld transmitter. Press the desired transmitter key until the flashing of the
yellow LED becomes a continuous light. If the yellow LED switches to continu-
ous light, the receiver has stored the coding.
NOTE
NOTE
17