BelFox 47-21-0 Instructions D'installation page 60

Drive overruns the
limit switch
automatic opening
instead of automatic
closing
Gate closes by itself
Gate opens by itself
Gate runs too long in
soft-run
Drive can be operated
by pushbutton or key
switch, but not with
the handheld trans-
mitter
low range of the
handheld transmitter
Magnet too far away
from the actuator.
Magnet fallen off Reed
switch defective
Direction of rotation of
the motor is not correct
automatic closing set
Automatic closing set
and direction of rotation
of the motor is not
correct
long soft run adjusted
Battery is empty,
Handheld transmitter is
defective, receiver is
defective
No coding taught-in;
antenna incorrectly
connected
Battery in handheld
transmitter is weak;
abnormally high interfe-
rence field;
unfavorable antenna
routing
28
Mount magnet closer to the
drive or drive closer to the
gate
Reattach magnet (glue) Re-
place reed switch
Change the direction of rota-
tion of the motor according
to point 5 of these instruc-
tions
Set DIP switch 3 to OFF
according to point 13
Set DIP switch 3 to OFF and
change the direction of rota-
tion (see point 5).
See point 10
Replace battery, test with
other handheld transmitter,
then send in handheld
transmitter or control unit
for repair if necessary;
Teach in coding; connect an-
tenna on motor control cor-
rectly (terminal 6).
Replace battery;
determine best position of
antenna with tests,
check receiver with other
handheld transmitters. If lar-
ge range is then obtained,
send the handheld transmit-
ter for repair.